tuto:linux:voir_l_etat_de_la_bande_passante_en_ligne_de_commande
Différences
Ci-dessous, les différences entre deux révisions de la page.
Les deux révisions précédentesRévision précédenteProchaine révision | Révision précédenteProchaine révisionLes deux révisions suivantes | ||
tuto:linux:voir_l_etat_de_la_bande_passante_en_ligne_de_commande [2009/10/23 19:35] – root | tuto:linux:voir_l_etat_de_la_bande_passante_en_ligne_de_commande [2010/04/01 20:42] – root | ||
---|---|---|---|
Ligne 28: | Ligne 28: | ||
exemple: | exemple: | ||
- | | + | < |
+ | * Par protocole : | ||
+ | < | ||
+ | iftop -f icmp | ||
+ | iftop -f tcp | ||
+ | iftop -f udp | ||
+ | </ | ||
+ | |||
+ | * Par réseau : | ||
+ | < | ||
+ | |||
+ | * Par ports : | ||
+ | < | ||
+ | iftop -f 'port 80' | ||
+ | iftop -f 'not port domain' | ||
+ | </ | ||
+ | |||
+ | * Par host : | ||
+ | < | ||
+ | |||
+ | * Divers : | ||
+ | < |
tuto/linux/voir_l_etat_de_la_bande_passante_en_ligne_de_commande.txt · Dernière modification : 2012/08/04 15:07 de root